+
  • 21AudiA4L-1.jpg
  • 21AudiA4L-2.png
  • 自制大众锁.png
  • EP12撑杆.jpg

2021-2025 Audi A4L, Corepine Smart Electric Tailgate System Kit


Category:


Get Quote

Share to

 

2. Product List

 

3. Installation method

1. Remove the indicated trim panels from the tailgate and hinges.

 

2. Remove the indicated trim panels and floor mat from the trunk.

 

3. Fold the all the rear seats.

 

4. Remove the original spring and thread two nuts with handle through the two holes indicated by yellow lines.

 

5. Installl the left body bracket.

 

6. Install the right body bracket.

 

7. Remove the indicated bump stops from the hinges on both sides.

 

8. Install the left tailgate bracket and provided bump stop. For the right hinge, only replace the bump stop.

 

9. Remove the damping rod.

 

10. Install the left strut (L&R are marked as the first letter of the strut code). Pay attention to the location of rubber tube.

 

11. Install the left strut (L&R are marked as the first letter of the strut code). Pay attention to the location of rubber tube.

 

12. Hang the original springs to the middle hole of our brackets

 

13. Route the strut wiring harnesses to the left side of trunk.

 

14. Remove the original latch.

 

15. Connect the lock signal harness to the plugs of the power latch.

 

16. Install the power latch.

 

17. Remove the indicated panel.

 

18. Connect the lock signal harness to the plugs of the original tailgate switch.

 

19. Ground at the indicated location on the left side of the trunk.

 

20. The fuse slot for power supply is indicated above.

 

21. Plug the fuse tap into the fuse box. Pay attention to the direction.

 

22. Drill a hole at the indicated location with a φ6mm drill bit.

 

23. Secure the ECU at the indicated location.

 

24. Insert the left and right strut wiring harnesses ①②, lock signal harness ③, and power harness④ into the ECU in sequence.

 

25. Check whether the power latch and the electric struts function well.

 

 

26. Press the added tailgate switch button to open and close the tailgate once for initializing the system, and then test each function of the electric tailgate.

 

 

27. The location for the added tailgate switch is as shown above. Stick the hole template to the indicated location.

 

28. Scrap off the indicated ribs of the original latch casing.

 

29. Fasten the latch casing securely to the tailgate trim panel.

 

30. Scrap the indicated part on the left side of the trunk to prevent interference with the spring.

 

31. Install the added tailgate switch and reinstall the all the trim panels.

 

4. System initialization method


1. Press the added tailgate switch button to make the tailgate close automatically;
2. Press the switch button outside the tailgate to open the tailgate and it will make a long sound of "beep".
3. The system initialization is complete.

 

5. Instructions for the electric tailgate


1. Methods to open and close the tailgate:
●Press the tailgate button on the remote key 2 times;
●Press the tailgate button at the driver's area;
●Press the original tailgate switch button;
●Press the added tailgate switch button.

3. Instructions for the added tailgate switch
①Closing speed acceleration (5 Settings)
1.Press and hold the switch button until hearing the first short beep sound.
2.After releasing the button, you will hear a short beep, indicating that the closing speed acceleration has taken effect. 
3.Repeat this step once to increase by one setting.
②Opening speed acceleration (5 Settings)
1.Press and hold the switch button until hearing the second short beep sound
2. After releasing the button, you will hear two short beeps, indicating that the opening speed acceleration has taken effect.
3. Repeat this step once to increase by one setting.
③Settings of the voice module
1.Press and hold the switch button until hearing the third short beep sound. 
2.After releasing the button, you will hear three short beeps, indicating that the voice module has entered configuration mode. (For details, see the voice module operation manual)
④Block the voice module
1.Press and hold the switch button until hearing the fourth beep sound. 
2.After releasing the button, you will hear four short beeps indicating that the voice module has been blocked.

⑤Height setting
1.Press and hold the switch button until hearing the fifth short beep sound.
2.After releasing the button, you will hear a long beep sound indicating that the height setting has taken effect.
⑥Switch between quick/slow press of the unlock button on remote key
1.Press and hold the switch button until hearing the sixth short beep sound.
2.After releasing the button, you will hear a long beep sound and a short beep sound indicating that the switch between quick and slow press of the unlock button has taken effect.
⑦Switch between pressing the unlock button twice/three times
1.Press and hold the switch button until hearing the seventh short beep sound.
2.After releasing the button, you will hear a long beep sound and two short beeps indicating that the switch between pressing the unlock button twice/three times has taken effect.
⑧Braking force increase (five settings)
1.Press and hold the switch button until hearing the eighth short beep sound.
2.After releasing the button, you will hear a long beep sound and three short beeps indicating that the switch between pressing the unlock button twice/three times has taken effect.
3.Repeat this step to increase by one setting.

⑨Restore to factory settings
1.Press and hold the switch button until hearing the ninth short beep sound.
2.After releasing the button, you will hear a long beep sound and four short beeps indicating that the restoration to the factory setting has taken effect.


6. Meanings of the buzzer sound:


"Beep" once: Receiving an open/close or pause signal, the tailgate will immediately open/close or pause;
"Beep" twice: The tailgate has been fully opened or closed;
"Beep" three times:The resistance during opening or closing the tailgate is too large, and the intelligent anti-pinch has been turned on.

 

Keywords:

2021-2025 Audi A4L, Corepine Smart Electric Tailgate System Kit

Get a Free Quote

*Note: Please be sure to fill in the information accurately and keep the communication open, we will get in touch with you as soon as possible

SUBMIT NOW