Power Running Board
No data

2. Product List

3. Installation method

1. Remove the tailgate trim panels.

2. Remove the trunk floor mat and trim panels.

3. Install the body brackets. Both sides follow the same methods.

4. The two brackets are symmetrical.

5. Install the tailgate bracket, aligning with the indicated hole.

6. Install the tailgate brackets (remove the wire clips that interfere with the bracket before installation).

7. Install the electric struts, L on the left and R on the right (the first letter of the strut code), making sure the ends with wiring harnesses are on the car body.

8. Tie the strut wiring harnesses along the original wires and route them along the hinges to the tailgate.

9. Remove the original latch and install our power latch.

10. Connect the connectors of the lock signal harness to the power latch (reinstall the original latch cable).

11. Connect the connectors of the lock signal harness to the original tailgate switch.

12. Install the added tailgate switch.

13. Route the emergency wires along the left hinge① to the left side of the rear seats②.

14. Route the power harness from the left hinge to the tailgate (routing only, no power connection).

15. Ground at the indicated location on the right side of the trunk.

16. The fuse box for power supply is on the left side of the trunk.

17. The fuse slot for power supply is indicated above.

18. Plug the fuse tap into the fuse box. Pay attention to the direction.

19. Insert the strut wiring harnesses ①②, lock signal harness ③, and power harness④ into the ECU in sequence.

20. Install the fuse box and secure it with a nut.

21. Confirm that the power latch and the electric struts work properly before continuing to install.

22. Test each function of the electric tailgate.

23. Reinstall all the trim panels (properly cut off the trim panels of the trunk and the hinges).
4. System initialization method
1. Press the added tailgate switch button to make the tailgate close automatically;
2. Press the switch button outside the tailgate to open the tailgate and it will make a long sound of "beep".
3. The system initialization is complete.
5. Instructions for the electric tailgate
1. Methods to open and close the tailgate:
●Press the tailgate button on the remote key;
●Press the tailgate button in the driver's area;
●Press the original tailgate switch button;
●Press the added tailgate switch button.
2. Method to pause the tailgate:
During the operation of the tailgate, press the button with any of the above methods, and the tailgate will be paused. Press again, and the tailgate will move in reverse.
3. Method to memorize the height:
Open the tailgate to the height you want to set, long press the added tailgate switch, and release the switch after hearing a long "beep ----" . The height memory is complete.
Tip: During the operation of the tailgate, pause the tailgate, and then push the tailgate to the ideal height with your hand.
6. Meanings of the buzzer sound:
"Beep" once: Receiving an open/close or pause signal, the tailgate will immediately open/close or pause;
"Beep" twice: The tailgate has been fully opened or closed;
"Beep" three times:The resistance during opening or closing the tailgate is too large, and the intelligent anti-pinch has been turned on;
Long sound of "beep": The height memory is complete.
Keywords:
SHOP