Power Running Board
No data

2. Product List

3. Installation method

1. Remove the front left door sill panel, storage box and the steering column trim panel.

2. Remove the rear left door sill panel and B-pillar trim panel.

3. Remove the trunk floor mat and the trim panels on the left side.

4. Pay attention to the locations of the screws and fasteners.

5. Remove the tailgate trim panels.

6. Remove the gas struts.

7. Replace the bracket on the left side of the car body making sure the ball stud is closer to the top of the bracket.

8. Replace the bracket on the right side of the car body making sure the ball stud is closer to the top of the bracket.

9. Install the electric struts, L on the left and R on the right (the first letter of the strut code).

10. Thread the strut wiring harness through the indicated hole into tailgate.

11. Route the strut wiring harnesses as indicated above.

12. Remove the original latch.

13. Install our power latch and cover the latch with original plastic casing.

14. Route the strut wiring harness to the left side of the trunk.

15. Insert the lock signal harness terminals into the connector on ECU.

16. Connect the lock signal harness to the plugs of the power latch.

17. Connect the lock signal harness to the plugs of the original tailgate switch.

18. Route the power harness.

19. Ground at the left side of the trunk.

20. Connect the power harness to the CAN signal plug and its socket inside the trim panel of steering column.

21. The fuse box is located at the driver's area and the slot for power supply is indicated above.

22. Plug the fuse tap into the fuse box. Pay attention to the direction.

23. Secure the ECU at the indicated position with a nut.

24.Insert the left and right strut wiring harnesses ①②, lock signal harness ③, and power harness④ into the ECU in sequence.

25. Press the added tailgate switch button to close the tailgate for initialization and test each function of the electric tailgate.

26. Remove the indicated small panel for installing the added tailgate switch.

27. Install the added tailgate switch and reinstall all trim panels.
4. System initialization method
1. Press the added tailgate switch button to make the tailgate close automatically;
2. Press the switch button outside the tailgate to open the tailgate and it will make a long sound of "beep".
3. The system initialization is complete.
5. Instructions for the electric tailgate
1. Methods to open and close the tailgate:
●Press and hole the tailgate button on the remote key (only accessible
when the vehicle has started);
●Press the original tailgate switch button to open;
●Press the added tailgate switch button to close.
2. Method to pause the tailgate:
During the operation of the tailgate, press the button with any of the above methods, and the tailgate will be paused. Press again, and the tailgate will move in reverse.
3. Method to memorize the height:
Open the tailgate to the height you want to set, long press the added tailgate switch, and release the switch after hearing a long "beep ----" . The height memory is complete.
Tip: During the operation of the tailgate, pause the tailgate, and then push the tailgate to the ideal height with your hand.
6. Meanings of the buzzer sound:
"Beep" once: Receiving an open/close or pause signal, the tailgate will immediately open/close or pause;
"Beep" twice: The tailgate has been fully opened or closed;
"Beep" three times:The resistance during opening or closing the tailgate is too large, and the intelligent anti-pinch has been turned on;
Long sound of "beep": The height memory is complete.
Keywords:
SHOP