Power Running Board
No data

2. Product List

3. Installation method

1. Remove the driver side door sill panels, fuse box trim panels and trim panels under the steering wheel.

2. Remove the rear left door sill panel and B-pillar trim panel.

3. Take out the trunk floor mat and remove the indicated trim panels on the left side of the trunk.

4. Remove the tailgate trim panels.

5. Remove the original latch.

6. Assemble the power latch.

7. Install the power latch motor.

8. Route the lock signal harness(Route only).

9. Insert the lock signal harness terminals into the connector according to the diagram. Then push inward to fasten the latches on both sides.

10. Connect the connectors of the lock signal harness to the original tailgate switch.

11. Connect the connectors of the lock signal harness to the power latch and added tailgate switch.

12. Remove the original gas struts.

13. Replace the body brackets on both sides. Position the ball-joint ends toward the upper side, then remove the original rubber plugs.

14. Install the electric struts, L on the left and R on the right (the first letter of the strut code). Thread the strut wiring harness through the indicated hole, seal the holes with the original rubber plugs

15. Route the left and right strut wiring harnesses to the left side of the trunk as indicated.

16. Route the power harness.

17. Ground at the left side of the trunk.

18. Plug in the signal connector on the steering column.

19. Plug the fuse tap as indicated(The position of constant power: 4th row from top, 7th from left).

20. Mount the control box bracket onto the original body hole on the left side of the trunk.

21. Insert the left and right strut wiring harnesses①②,lock signal harness③,and power harness④ into the ECU in sequence.

22. Press the added tailgate switch button to close the tailgate once, the system completes initialization, and then test each function of the electric tailgate.

23. Install the added tailgate switch and reinstall all the trim panels(Remove the original blank cover).
4. System initialization method
1. Press the added tailgate switch button, and the tailgate will close automatically;
2. Press the tailgate switch button outside the tailgate to open the tailgate and it will make a long sound of "beep".
3. The system initialization is complete.
5. Instructions for the electric tailgate
1. Methods to open and close the tailgate:
●Press the unlock button on the remote key 3 times;
●Press and hold the tailgate button on the remote key;
●Press the unlock button at the driver's area 3 times;
●Press the original tailgate switch button;
●Press the added tailgate switch button;
2. Method to pause the tailgate:
During the operation of the tailgate, press the button with any of the above methods, and the tailgate will be paused. Press again, and the tailgate will move in reverse.
3. Instructions for the added tailgate switch
Adjust the tailgate to your desired height, then press and hold the added tailgate switch. Release the switch after hearing a long beep sound which indicates the height setting is completed.
Tip: During the operation of the tailgate, pause the tailgate, and then push the tailgate to the ideal height.
6. Meanings of the buzzer sound:
"Beep" once: Receiving an open/close or pause signal, the tailgate will immediately open/close or pause;
"Beep" twice: The tailgate has been fully opened or closed;
"Beep" three times:The resistance during opening or closing the tailgate is too large, and the intelligent anti-pinch has been turned on;
Long sound of "beep": The height memory is complete.
Keywords:
SHOP