Power Running Board
No data

2. Product list

3. Installation method

1. Remove the left side door sill panels to allow wiring harnesses to pass through.

2. Remove the the tailgate trim panels.

3. Remove the original latch and install our power latch.

4. Connect the connectors of the lock signal harness to the original tailgate switch.

5. Connect the connectors of the lock signal harness to the power latch and the added tailgate switch.

6. Remove the gas struts (remove the screws from the bracket).

7. Install the left body bracket

8. Install the right body bracket.

9. Install the left tailgate bracket.

10. Install the right tailgate bracket.

11. Install the electric struts, L on the left, R on the right (the first letter of the strut code).

12. Thread the strut wire harness through the indicated hole into the tailgate.

13. Route the strut wiring harnesses.

14. Route the power harness to the tailgate.

15. Insert the power harness terminals into the wiring harness connector as indicated above.

16. Route the power harness (the signal connector of RHD model is located at the right side of the car).

17. Ground at the middle part of the tailgate.

18. Connect the connectors of the power harness to the signal plug and its socket.

19. Install the added front switch at the location of the blank button and connect the plugs behind the switch.

20. The slot location on the fuse box for power supply is indicated above.

21. Plug the fuse tap into the fuse box and pay attention to the direction.

22. Place the ECU bracket at the indicated position and secure it with a nut.

23. Insert the strut wire harnesses①②, lock signal harness ③, and power harness④ into the ECU in sequence, and then mount the ECU on its bracket.

24. Press the added tailgate switch to open and close the tailgate once for initializing the system, and then test each function of the electric tailgate.

25. Reinstall all the trim panels and install the added tailgate switch.
4. System initialization method
1. Press the added tailgate switch button to make the tailgate close automatically;
2. Press the switch button outside the tailgate to open the tailgate and it will make a long sound of "beep".
3. The system initialization is complete.
5. Instructions for the electric tailgate
1. Methods to open and close the tailgate:
●Press the unlock button on the remote key 3 times;
●Press the unlock button at the driver's area 3 times;
●Press the original tailgate switch button to open;
●Press the added tailgate switch button to close;
●Press the front tailgate switch button: press and hold for 4s to open.
2. Method to pause the tailgate:
During the operation of the tailgate, press the button with any of the above methods, and the tailgate will be paused. Press again, and the tailgate will move in reverse.
3. Method to memorize the height:
Open the tailgate to the height you want to set, long press the added tailgate switch, and release the switch after hearing a long "beep ----" . The height memory is complete.
Tip: During the operation of the tailgate, pause the tailgate, and then push the tailgate to the ideal height with your hand.
6. Meanings of the buzzer sound:
"Beep" once: Receiving an open/close or pause signal, the tailgate will immediately open/close or pause;
"Beep" twice: The tailgate has been fully opened or closed;
"Beep" three times:The resistance during opening or closing the tailgate is too large, and the intelligent anti-pinch has been turned on;
Long sound of "beep": The height memory is complete.
Keywords:
SHOP