Power Running Board
No data

2. Produc list

3. Installation method

1. Remove the indicated driver’s side trim panels and stepboard.

2. Remove the rear left stepboard to allow wiring harnesses to pass through.

3. Remove the trim panels on the tailgate and the right side of the trunk.

4. Remove the original gas struts.

5. Replace the left body bracket.

6. Replace the right body bracket.

7. Replace the left and right tailgate brackets.

8. Install the electric struts, L on the left, R on the right (the first letter of the strut code), making sure the ends with wiring harnesses are on the vehicle body.

9. Thread the strut wiring harness into the tailgate through the circled hole, and then plug the hole with the hole plug. Both sides follow the same method.

10. Route the strut wiring harnesses.

11. Connect the connectors of the lock signal harness to the original tailgate switch. (Two pairs of plugs are provided, choose the appropriate one according to the original connectors)

12. Connect connectors of the lock signal harness to the power latch.

13. Connect the connector of the lock signal harness to the added tailgate switch.

14. Route the power harness to the tailgate (do not connect power before inserting terminals into wiring harness connector).

15. Insert the power harness terminals into the wiring harness connector as shown above.

16. Route the power harness as shown.

17. Ground at the indicated position on the tailgate.

18. Connect the power harness to the signal plug and its socket beside the pedals.

19. Remove the blank button from the switch panel and install the added front switch. (connect the plugs for backlight behind the switch panel)

20. The location of the fuse slot for power supply is indicated in the diagram.

21. Move the original fuse from the fuse box to the fuse tap and then plug the fuse tap into the fuse box. Pay attention to the direction.

22. Secure the ECU bracket at the indicated hole.

23. Insert the strut wiring harnesses ①②, lock signal harness ③, and power harness④ into the ECU in sequence, and fit the ECU into its bracket.

24. Press the added tailgate switch to initialize the system once, and then test the functions of the electric tailgate.

25. Reinstall all the trim panels and install the added tailgate switch.
4. System initialization method
1. Press the added tailgate switch button to make the tailgate close automatically;
2. Press the switch button outside the tailgate to open the tailgate and it will make a long sound of "beep".
3. The system initialization is complete.
5. Instructions for the electric tailgate
1. Methods to open and close the tailgate:
●Press the unlock button on the remote key 3 times;
●Press the unlock button in the driver's area 3 times;
●Press the original tailgate switch button;
●Press the added tailgate switch button to close;
●Press the added front switch button: press and hold for 4s to open and
press once to close.
2. Method to pause the tailgate:
During the operation of the tailgate, press the button with any of the above methods, and the tailgate will be paused. Press again, and the tailgate will move in reverse.
3. Method to memorize the height:
Open the tailgate to the height you want to set, long press the added tailgate switch, and release the switch after hearing a long "beep ----" . The height memory is complete.
Tip: During the operation of the tailgate, pause the tailgate, and then push the tailgate to the ideal height with your hand.
6. Meanings of the buzzer sound:
"Beep" once: Receiving an open/close or pause signal, the tailgate will immediately open/close or pause;
"Beep" twice: The tailgate has been fully opened or closed;
"Beep" three times:The resistance during opening or closing the tailgate is too large, and the intelligent anti-pinch has been turned on;
Long sound of "beep": The height memory is complete.
Keywords:
SHOP