Power Running Board
No data

2. Product list

3. Installation method

1. Separate the two steering column trim panels.

2. Remove the front left side trim panel, door sill panel and storage box.

3. Remove the rear left side door sill panel and B-pillar trim panel.

4. Remove the tailgate trim panels.

5. Take out the trunk floor mat and remove the left side trim panels.

6. Assemble the lock latch and actuator.

7. Locate the mounting holes of the lock actuator.

8. Connect the connectors of the lock signal harness to the original tailgate switch.

9. Remove the original latch and install our latch and actuator.

10. Connect the connectors of the lock signal harness to the lock latch, actuator and the added tailgate switch.

11. Remove the original gas struts.

12. Remove the ball stud from the tailgate and move the plug from its original position to the threaded hole of the ball stud. Both sides are the same.

13. Install the new ball studs on the tailgate. Both sides are the same.

14. Replace the ball studs on the car body.

15. Install the electric struts, L on the left and R on the right (the first letter of the strut code).

16. Thread the strut wiring harnesses through the car hole and plug the hole tightly. Both sides are the same.

17. Route the strut wiring harnesses.

18. Thread the power harness to the tailgate.

19. Insert the power harness terminals into the wiring harness connector as shown above.

20. Route the power harness.

21. Ground at the indicated position on the left side of the trunk.

22. Connect the plugs of the power harness to the indicated signal plug and its socket.

23. The fuse slot for power supply is indicated above.

24. Plug the fuse tap into the fuse box and pay attention to the direction.

25. Secure the ECU bracket at the indicated hole on the left side of the tailgate.

26. Insert the strut wiring harnesses ①②, lock signal harness ③, and power harness④ into the ECU in sequence.

27. Press the tailgate switch buttons to open and close the tailgate once for initializing the system, and then test each function of the electric tailgate.

28. Enlarge the indicated hole for the installation of the added tailgate switch.

29. Align the trim panel with the enlarged hole on the tailgate and open a hole for the added tailgate switch.

30. Reinstall all trim panels and fit the added tailgate switch in.
4. System initialization method
1. Press the added tailgate switch button to make the tailgate close automatically;
2. Press the switch button outside the tailgate to open the tailgate and it will make a long sound of "beep".
3. The system initialization is complete
5. Instructions for the electric tailgate
1. Methods to open and close the tailgate:
●Press and hold the tailgate button on the remote key;
●Press the unlock button in the driver's area 5-6 times;
●Press the original tailgate switch button;
●Press the added tailgate switch button to close.
2. Method to pause the tailgate:
During the operation of the tailgate, press the button with any of the above methods, and the tailgate will be paused. Press again, and the tailgate will move in reverse.
3. Method to memorize the height:
Open the tailgate to the height you want to set, long press the added tailgate switch, and release the switch after hearing a long "beep ----" . The height memory is complete.
Tip: During the operation of the tailgate, pause the tailgate, and then push the tailgate to the ideal height with your hand.
6. Meanings of the buzzer sound:
"Beep" once: Receiving an open/close or pause signal, the tailgate will immediately open/close or pause;
"Beep" twice: The tailgate has been fully opened or closed;
"Beep" three times:The resistance during opening or closing the tailgate is too large, and the intelligent anti-pinch has been turned on;
Long sound of "beep": The height memory is complete.
Keywords:
SHOP