+
  • 22BENZGLA (1).png
  • 22BENZGLA (2).png
  • 奔驰B级锁.png
  • EP11撑杆.png

2022-2023 Benz GLA,Corepine Smart Electric Tailgate System Kit


Category:


Get Quote

Share to

 

2. Product list

 

3. Installation method

 

1. Remove the trim panels from the trunk and tailgate.

 

2. Remove the front right side trim panels.

 

3. Find out the fuse box under the floor mat of front passenger seat.

 

4. Remove the rear right door sill panel.

 

5. Remove the original gas struts.

 

6. Mount the bracket on the left side of car body.

 

7. Mount the bracket on the right side of the car body.

 

8. Replace the original ball studs on both sides of the tailgate with provided ball studs.

 

9. Install the electric struts, L on the left and R on the right (the first letter of the strut code).

 

10. Install the electric struts, L on the left and R on the right (the first letter of the strut code).

 

11. Route the left and right strut wiring harness to the tailgate and then connect them to the ECU.

 

12. Insert the strut wiring harness terminals into the wiring harness connector.

 

 

13. Remove the original latch.

 

14. Connect the connectors of the lock signal harness to the power latch.

 

15. Install the power latch.

 

16. Find out the connector of outer tailgate button.

 

17. Connect the plugs of lock signal harness to the plugs of the original tailgate button.

 

18. Route the power harness.

 

19. Route the power harness to the tailgate.

 

20. Insert the power harness terminals into the wiring harness connector according to the diagram.

 

21. Ground at the indicated locaion by the ground wire connector.

 

22. Connect the connectors of power harness to the signal connectors at the right side of front passenger seat.

 

23. Connect the ring terminal to the fuse box for power supply.

 

24. Put a bolt on the bracket and then mount the ECU onto the bracket.

 

25. Remove the wire clip form the indicated hole and secure the ECU at the hole with a nut.

 

26. Insert the strut wiring harnesses ①②, lock signal harness ③, and power harness④ into the ECU in sequence.

 

27. Press the added tailgate switch to close the tailgate once, the system complete initialization and then test each function of the electric tailgate.

 

28. Reinstall all the trim panels and install the added switch  (Check if the added switch can bounce back normally when pressed. If there is any interference, use a small knife to scrape off the interfering part of the trim panel).

 

(Optional) Find an appropriate position in the driver's area, drill a φ21mm hole and install the added front switch.

 

4. System initialization method


1. Press the added tailgate switch button to make the tailgate close automatically;
2. Press the switch button outside the tailgate to open the tailgate and it will make a long sound of "beep".
3. The system initialization is complete.

 

5. Instructions for the electric tailgate


1. Methods to open and close the tailgate:
●Press the unlock button on the remote key 3 times;
●Press the unlock button at the driver's area 3 times;
●Press the original tailgate switch button;
●Press the added tailgate switch button;
●Press the added front switch button: press and hold for 4s to open and
  press once to close.

2. Method to pause the tailgate:
During the operation of the tailgate, press the button with any of the above methods, and the tailgate will be paused. Press again, and the tailgate will move in reverse.

3. Method to memorize the height:
Open the tailgate to the height you want to set, long press the added tailgate switch, and release the switch after  hearing a long "beep ----" . The height memory is complete.
Tip: During the operation of the tailgate, pause the tailgate, and then push the tailgate to the ideal height with your hand.

 

6. Meanings of the buzzer sound:


"Beep" once: Receiving an open/close or pause signal, the tailgate will immediately open/close or pause;
"Beep" twice: The tailgate has been fully opened or closed;
"Beep" three times:The resistance during opening or closing the tailgate is too large, and the intelligent anti-pinch has been turned on;
Long sound of "beep": The height memory is complete.

 

 

Keywords:

2022-2023 Benz GLA,Corepine Smart Electric Tailgate System Kit

Get a Free Quote

*Note: Please be sure to fill in the information accurately and keep the communication open, we will get in touch with you as soon as possible

SUBMIT NOW