Power Running Board
No data

2. Product list

3. Installation method

1. Remove the front right side door sill panel and storage box as shown in the diagram.

2. Remove the right middle door sill panel.

3. Remove the right side trim panel from the trunk to allow the strut wiring harnesses to pass through.

4. Remove the tailgate trim panels.

5. Remove the original latch.

6. Connect the plugs of the lock signal harness to the plugs of the power latch.

7. Install the power latch.

8. Connect the plugs of the lock signal harness to the plugs of the original tailgate switch.

9. Connect the plug of the lock signal harness to the added tailgate switch.

10. Remove the original gas struts.

11. Replace the left tailgate bracket.

12. Replace the right tailgate bracket.

13. Replace the left body bracket.

14. Replace the right body bracket.

15. Install the electric struts, L on the left and R on the right (the first letter of the strut code), making sure the ends with wiring harnesses are on the tailgate.

16. Drill a ø21mm hole at the top of tailgate to allow the strut wiring harness to pass through as indicated above.

17. Route the strut wiring harnesses.

18. Put the left and right rubber plugs into holes.

19. Thread the power harness to the tailgate (do not connect plugs before inserting terminals into the wiring harness connector).

20. Insert the power harness terminals into the wiring harness connector according to the diagram.

21. Route the power harness.

22. Plug in the signal plug at the right side of the passenger storage box.

23. Ground at the lower right side of front passenger seat.

24. Connect to the indicated position with red wire connector for constant power (add a provided nut).

25. Use a ø6mm drill bit to drill a mounting hole for the ECU bracket.

26. Insert the strut wiring harnesses ①②, lock signal harness ③, and power harness④ into the ECU in sequence and then mount the ECU onto its bracket.

27. Press the added tailgate switch to close the tailgate once, and then test each function of the electric tailgate.

28. Stick the hole template to the indicated position and open a hole for the added tailgate switch.

29. Reinstall all the trim panels and install the added tailgate switch.

30. Replace the left and right bump stops.
4. System initialization method
1. Press the added tailgate switch button to make the tailgate close automatically;
2. Press the switch button outside the tailgate to open the tailgate and it will make a long sound of "beep".
3. The system initialization is complete.
5. Instructions for the electric tailgate
1. Methods to open and close the tailgate:
●Press the unlock button on the remote key 3 times;
●Press the unlock button at the driver's area 3 times;
●Press the original tailgate switch button;
●Press the added tailgate switch button to close.
2. Method to pause the tailgate:
During the operation of the tailgate, press the button with any of the above methods, and the tailgate will be paused. Press again, and the tailgate will move in reverse.
3. Method to memorize the height:
Open the tailgate to the height you want to set, long press the added tailgate switch, and release the switch after hearing a long "beep ----" . The height memory is complete.
Tip: During the operation of the tailgate, pause the tailgate, and then push the tailgate to the ideal height with your hand.
6. Meanings of the buzzer sound:
"Beep" once: Receiving an open/close or pause signal, the tailgate will immediately open/close or pause;
"Beep" twice: The tailgate has been fully opened or closed;
"Beep" three times:The resistance during opening or closing the tailgate is too large, and the intelligent anti-pinch has been turned on;
Long sound of "beep": The height memory is complete.
Keywords:
SHOP