Power Running Board
No data

2. Product list

3. Installation method

1. Remove the tailgate trim panels.

2. Remove the trim panels on the right side of the trunk.

3. Remove the original gas struts.

4. Install the electric struts, L on the left and R on the right (the first letter of the strut code), making sure the ends with wire harnesses are on the tailgate.

5. Drill a hole at the indicated position with a φ21mm drill bit to allow strut wire harness to pass through. Same on both sides.

6. Thread the left and right strut wire harnesses through the drilled holes into the tailgate.

7. Seal the holes with hole plugs on both sides.

8. Connect the connectors of lock signal harness to the original latch

If the connectors can not be connected,①cut off the connectors to expose the purple wire and blue-whire wire.

②Clamp the indicated wires of the original latch connector.

9. Connect the connectors of lock signal harness to the original tailgate switch.

10. Route the power harness.

11. Ground at the right side of the tailgate.

12. Insert the power harness terminals into the connector according to the wire labels.

13. Connect the connectors of power harness to the connectors of unlock signal behind the fuse box.

14. Connect the wire connector to the indicated location for power supply.

15. Drill a hole at the indicated location.

16. Install the ECU and secure it with a nut (the nut is located on ECU).

17. Insert the blue/white wire terminal of lock signal harness into the fifth slot of the power harness connector.

18. Insert the left and right strut wire harnesses ①②, lock signal harness ③, and power harness④ into the ECU in sequence.

19. Press the added tailgate switch button to close the tailgate for initialization and test each function of the electric tailgate.

20. Remove the tailgate handle light and adjust the hole size to fit the added switch.

21. Connect the handle light to its connector and put it inside the tailgate trim panel.

22. Install the added tailgate switch and install all trim panels back.

5. System initialization method
1. Press the added tailgate switch button to make the tailgate close automatically;
2. Press the switch button outside the tailgate to open the tailgate and it will make a long sound of "beep".
3. The system initialization is complete.
6. Instructions for the electric tailgate
1. Methods to open and close the tailgate:
●Press the unlock button on the remote key 3 times;
●Press the unlock button at the driver's area 3 times;
●Press the original tailgate switch button;
●Press the added tailgate switch button.
2. Method to pause the tailgate:
During the operation of the tailgate, press the button with any of the above methods, and the tailgate will be paused. Press again, and the tailgate will move in reverse.
3. Method to memorize the height:
Open the tailgate to the height you want to set, long press the added tailgate switch, and release the switch after hearing a long "beep ----" . The height memory is complete.
Tip: During the operation of the tailgate, pause the tailgate, and then push the tailgate to the ideal height with your hand.
4. Meanings of the buzzer sound:
"Beep" once: Receiving an open/close or pause signal, the tailgate will immediately open/close or pause;
"Beep" twice: The tailgate has been fully opened or closed;
"Beep" three times:The resistance during opening or closing the tailgate is too large, and the intelligent anti-pinch has been turned on;
Long sound of "beep": The height memory is complete.
Keywords:
SHOP